Gluing white oak panels
Because of its density, white oak lumber must be machined carefully for panel glue-up, and assembled within an hour of preparation. 1998.
by Professor Gene Wengert
Could you suggest some reference material that might explain the proper techniques and practices for gluing White Oak panels on a Taylor Clamp? We are pretty good at making edge-glued panels from Alder and Hemlock cutstock, but we understand White Oak is a totally different animal requiring special procedures and considerations. This is for a commercial manufacturing application. Panels will be used for furniture components and cabinet doors, etc.
I do not have anything specific, but as you may know, the pressure needs to be increased and the surfaces must be perfectly flat and true as there is no room for error when drying such a hard, dense wood. In other words, rip the edges, joint them if required, and glue them within an hour. As oak shrinks much more than alder or hemlock, you will have to be much more certain of the MC too. This subject is discussed in THE WOOD DOCTOR'S RX book which is available from the Robert Byrd Hardwood Technology Center.
Professor Gene Wengert is Extension Specialist in Wood Processing at the Department of Forestry, University of Wisconsin-Madison.
Click on Wood Doctor Archives to peruse past answers.
If you would like to obtain a copy of "The Wood Doctor's Rx", visit the Wood Education and Resource Center Web site for more information.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Adhesives, Gluing and Laminating: Gluing and Clamping Equipment
KnowledgeBase: Primary Processing: General
KnowledgeBase: Solid Wood Machining: General
KnowledgeBase: Wood Engineering: Wood Properties
KnowledgeBase: Woodworking Miscellaneous: Woodworking
KnowledgeBase: Knowledge Base
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com